Hospital - Respirator FFP3 NR (30 pcs)
Hospital - Respirator FFP3 NR (30 pcs)

Hospital - Respirator FFP3 NR (30 pcs)

Regular price €120,00
Unit price  per 


This product consists of PP nonwoven fabric, PP melt-blown fabric, hot air nonwoven fabric, nose clip and headband.


This product, which is normally used in the general working environment, is designed to provide reliable respiratory protection and against certain airborne particles and dust, block body fluids and so on.


Meet the requirements of EN 149:2001 +A1:2009 for protective respirators


  1. This mask marked “NR” , shall not be used for more than one shift.
  2. Never substitute, modify, add, or omit parts in the configuration as specified by the manufacturer.
  3. This mask helps protect against certain particulate contaminants but does not completely eliminate exposure to the risk of contracting disease or infection.
  4. Do not use the particle half mask with facial hair or any other conditions that may prevent a good face-seal, the requirements of leakage will not be achieved.
  5. Discard the mask and replace the mask if:

    a) The mask is removed whilst in the contaminated areas;

    b) Clogging of the mask causes breathing difficulties. 

    c) The mask becomes damaged.


People allergic to nonwoven are prohibited to use. Not recommended for use in anoxic and explosive atmospheres.


Keep masks in the package away from direct sunlight or contaminants until use. Ambient temperature between -30°C to +40°C, and relative humidity <80%, no corrosive gas, good ventilation. During the transportation, keep away from moisture, light and heat. The mask should not be removed from its package until it is required for use, and should be discarded after



  1. To protect your health and to prevent serious injury or death, it is important to read all the instructions provided with the enclosed product. Please read all warnings printed on the packaging box.
  2. The mask need to be inspected prior to each use, assure there are no holes in the breathing zone other than punctures around and staples and no damage has occurred.


1. Hold the particle half mask in position over the nose and mouth.
2. Pull the upper headband over the head positioning it just above the ears. Pull lower headband over the head and fit around the back of the neck. Tie the headband on the fixed position of head harness adjusting button.
3. Ensure the nose clip is securely molded around the nose , resting the ends against the cheek to obtain a good seal.
4. To check for proper fit , cup both hands over the mask and exhale vigorously . If air leaks around the nose , tighten the nose clip , if air leaks around the edge , reposition the headhamess for better fit. Repeat adjustments until the mask is sealed properly.


Do not use the mask to enter or stay in a contaminated area under the following circumstances:

  1. Atmosphere contains less than 19.5% oxygen.
  2. If you smell or taste contaminant.
  3. For protection against gases or vapors.
  4. Contaminants or their concentrations are unknown or immediately dangerous to life or health.
  5. For sandblasting, spray-paint operations and asbestos treatment.
  6. In explosive atmospheres.